![]() Back on the Win7 computer I tried using the command prompt to open altera\11.2sp2\quartus\bin\jtagconfig.exe and saw it read out the message "No JTAG hardware available". ![]() Under Unspecified, USB Blaster should be listed. Open the Device and Printers (Control Panel Devices and Printers). In troubleshooting, I also tried installing the same version of Quartus II and the USB blaster on my Win10 laptop, but the driver isn't signed for win10 so I dropped that approach. To install the driver for your USB Blaster cable, follow the instruction for your particular operating system. ![]() After connecting the USB Blaster to my Win7 computer for the first time and installing the driver from altera\11.1sp2\quartus\drivers, the USB Blaster shows up in the control panel as "USB-Blaster(Altera)" but Quartus II doesn't show it in the Programmer's Hardware Setup page. ![]() Because I have this Ep2c5/ep2c8 dev board, I've been following this video to begin my work with FPGAs:
0 Comments
Leave a Reply. |